Installation Checklist

The following checklist provides the basic steps for connecting, mounting and configuring a Motus unit.

1. Securely mount the unit to the vehicle following the Mounting Motus

2. Plug the IO cable into the IO connector on the Motus unit.

3. Connect the Motus to a device by the following:

   1. Connect the USB to RS232 / RS422 adaptor cable to the Primary port and your computer. The factory default setting is RS232. Check that the mode switch is at the correct setting.

   2. Java 11 is required to run Motus Manager. Adoptium JRE 11 is the recommended Java installer to be used on all platforms. Install the latest version of Java 11 from Adoptium, selecting the correct operating system and architecture for your computer.

   3. Download Motus Manager from the Motus product page of the Advanced Navigation website.

      Note: Motus Manager is only available for systems with x64 architecture and ARM architecture.

   4. Double click Motus Manager to start the application. See Using Motus Manager for specific notes for different platforms

   5. Select the correct COM port.

   6. Select the Baud Rate. The default baud rate is 115200 bps.

   7. Click Connect. If you are unable to connect, see Troubleshooting.

4. Mount the unit in the standard alignment of X+ pointing forward and Z+ pointing down. For more information, see Mounting Alignment.

5. Choose a Vehicle Profile in the Filter Options dialogue under the Configuration menu. This should be the closest available match to your vehicle type. If you need more information or assistance, contact technical support via email at support@advancednavigation.com.

6. Check that all filters are initialised. See Filter Initialisation.

   The system is now ready for use.